Atacama SLX Speaker Stands

The Atacama SLX range of speaker stands are available in a wide range of height options and cater for when a larger top plate is required.

SLX Series are supplied in a Satin Black paint finish with Diamond White as a cost option.

Each pair of SLX stands includes new 5mm thick laser cut carbon steel base plates, eight BZP 8mm adjustable floor spikes featuring stainless steel detailed top caps and upgraded High Load Trapezoidal (HLT) Isolation Gel Pads for the top plates.

We recommend that each pair be mass-loaded with Atabites in order to maximize their sonic potential (see below for quantity guidance and recommendations on the amount of mass filler to use).

Floor spikes and HLT Isolation Gel pads are included with each pair of stands, with the option of adding Atabite mass loading filler, top spikes and spike shoes if required.

SLX speaker stands use isolation spikes, two sets of four Atacama HD-S spike shoes are recommended to protect delicate floor coverings.

Single stands can be supplied if required; please contact your local Atacama stockist or the Atacama sales department on 01455 283251 for pricing and availability (UK only).

SLX speaker stands are designed and manufactured in the UK.

Colours

Black is available in 300mm, 400mm, 600mm and 700mm. White stands and other sizes are available as a special order, please call!

Dimensions:-

Overall Height (Including HLT Gel Pads and Floor Spikes)

SLX 200      235mm   (9.25”) (special order please call!)
SLX 300      335mm   (13.19”)
SLX 400      435mm   (17.12”)
SLX 500      535mm   (21.06”) (special order please call!)
SLX 600      635mm   (25”)
SLX 700      735mm   (28.9″)
SLX 1000   1035mm  (40.7”) (special order please call!)

Top Plate Dimensions

Width 225mm (8.9”), Depth 225mm (8.9”)

Base Plate Dimensions

Width 305mm (12”), Depth 305mm (12”)

Weight Capacity 15 kg per stand.

Note- Supported speaker width/depth dimensions should not exceed speaker stand base plate dimensions.

Atacama recommends Atabite SMD-Z 7HD inert filler to achieve maximum sonic performance.

 Atabite quantity recommendation

Below are the recommended number of tubes to share between each pair of speaker stands. All vertical poles should be equally filled. Amounts are approximate and will not necessarily completely fill the tubes. It is suggested that you experiment with the exact amount to achieve the best sonic results for your particular system setup as the speakers, room acoustics, cable loom, positioning of the speakers and hi-fi components will determine how much Atabite filler to use to get the best sound from your speakers.

As a general rule, approximately half to two-thirds full gives the best results. If you find the speakers are lacking high-end detail and sounding dull at the lower end that usually means you have overfilled the stands and will need to reduce the volume of Atabites in each stand.

If the speakers are new, it is suggested that the exact amount of Atabites needed will best be determined once they are run in. Refer to your speaker instructions or contact the supplying retailer/ manufacturer for guidelines on running in recommendations.

SLX 200     1 Tub           SLX 500     4 Tubs      SLX1000  7 Tubs
SLX 300     2 Tubs         SLX 600     5 Tubs
SLX 400     3 Tubs         SLX 700     6 Tubs