$7,330.00 inc. GST
The Soundsmith Paua MKII features a seashell inlay to remind us of the beauty of the sounds of the world all around us. Nature healing nature.
The Paua is one of Soundsmith’s most highly regarded top of the line low output cartridges. It has won numerous accolades and praise from users and reviewers around the world, including an “Editor’s Choice Award” in 2015 from TAS.
Featuring ultra-low internal moving mass, a specialized telescoping alloy cantilever and a highly polished low mass nude Contact Line stylus, the Paua will add a unique quality of warmth and smoothness to any analog system without leaving behind all the critical details you want and need to hear. The Paua reaches new heights of stylus control and performance, as is confirmed by its incredibly high channel separation figures.
Sounsmith has accomplished a work of art with the Paua design, resulting in an unparalleled and sublime performance.
Stylus: Contact Line Nude, 0.100mm SQ
Radius of curvature: Nude Contact Line SELECTED
Cantilever: Telescoping Aluminum Alloy
Recommended tracking force: 1.7 to 1.9 grams
Effective tip mass: 0.30 mg
Compliance: 10 μm/mN (low compliance)
Frequency response: 20-20,000 Hz ± 1.0 dB
Channel separation (stereo only): 1000 Hz >34 dB 50-15,000 >25 dB
Channel difference: <0.5 dB (Stereo), <1.0 dB (Mono)
Output Voltage: ≥0.4 mV
Cartridge weight: 12.2 grams
Loading: ≥ 470 Ω
ES Cartridges with “DEMS”
Sometimes when mounting on a grounded metal arm, a cartridge will create a hum due to a ground loop. If you experience some low-level hum due to the ground loop, you can now solve this issue by using the two half-round white rods which are to be placed and used in the OUTER slots, seen on the top of the cartridge. Place them flat side UP.
The rods are made of Alumina, and are insulating, thus allowing ground isolation for your cartridge without compromising the crucial mechanical energy transfer into the tonearm. This energy transfer is maintained due to the use of Alumina, which has the same properties as aluminium but is non-conductive. Due to the novel body design of the ES cartridge, electrical isolation can still be maintained even though you may use metal screws.
On tonearms that do not allow azimuth adjustment, it is now possible to achieve this adjustment by way of the ES series by using the one full round alumina rod in the centre slot only, alternately tightening and loosening the mounting screws by small amounts.
Also available in dual-coil mono.
See Soundsmith product range HERE