Mon-Fri 9am - 5.30pm / Sat 9am - 5pm / Sun - Closed
FREE SHIPPING IN AUS(Orders Over $300)

Soundsmith Sussurro MKII Cartridge

$9,710.00 inc. GST

Category: Tags: , Brand:

Description

The Soundsmith Sussurro MKII ~ critical design decisions realized. Lowest internal mass. Best damping. Esoteric stylus and cantilever.
Inspired by Frank Schröder, designed and individually hand made by Peter Ledermann, Soundsmith‘s Sussurro is a cartridge designed to specifically address the most intricate and critical issues of cartridge design. The new Sussurro MKII has a newly designed moving iron element to reduce moving mass by 70%. The resulting extremely low stored inertia, with a newly engineered damping system and innovative energy distribution path, allows proper coupling into the tonearm. So what does all this mean?? Low jitter. Jitter? You probably thought that was a term reserved for digital systems. Not so. Stylus jitter is responsible for the loss of detail and making a cartridge sound, well, like a cartridge.

Soundsmith Sussurro MKII Specs:

LOW OUTPUT

Stylus: Contact Line Nude, 0.100mm SQ
Radius of curvature: OCL (Optimized Contour Contact Line) SELECTED
Cantilever: Ruby
Recommended tracking force: 1.8 to 2.2 grams
Effective tip mass: 0.30 mg
Compliance: 10μm/mN (low compliance)
Frequency response: 20-20,000 Hz ± 1.0 dB
Channel separation (stereo only): 1000 Hz >34 dB, 50-15,000 >25 dB
Channel difference: <0.5 dB (Stereo) <1.0 dB (Mono)
Output Voltage: ≥0.4 mV
Cartridge weight: 12.2 grams
Loading: ≥ 470 Ω

Also available in dual-coil mono.

ES Cartridges with “DEMS”

Sometimes when mounting on a grounded metal arm, a cartridge will create hum due to a ground loop. If you experience some low-level hum due to ground loop, you can now solve this issue by using the two half-round white rods which are to be placed and used in the OUTER slots, seen on the top of the cartridge. Place them flat side UP.

The rods are made of Alumina, and are insulating, thus allowing ground isolation for your cartridge without compromising the crucial mechanical energy transfer into the tonearm. This energy transfer is maintained due to the use of Alumina, which has the same properties as aluminium but is non-conductive. Due to the novel body design of the ES cartridge, electrical isolation can still be maintained even though you may use metal screws.

Soundsmith ES DEMS 1&2

On tonearms that do not allow azimuth adjustment, it is now possible to achieve this adjustment by way of the ES series by using the one full round alumina rod in the centre slot only, alternately tightening and loosening the mounting screws by small amounts.

Soundsmith ES DEMS 3

 

See Soundsmith product range HERE

Additional Information

Enquiry