Mon-Fri 9am - 5.30pm / Sat 9am - 5pm / Sun - Closed
FREE SHIPPING IN AUS(Orders Over $300)

Krix Neuphonix-AE40 Floorstanding Speakers

$6,595.00 inc. GST

Description

  • 40 pairs only
  • premium components
  • angled front baffle

To celebrate 40 years, Krix has released a limited edition version of its flagship speaker, the Neuphonix. Limited to 40 pairs only and boasting a new tweeter, drivers, cabinet design and terminal plates, these anniversary speakers are nothing short of stunning.

For the stereo aficionado, performance has been tuned with dedicated two channel music in mind. A Scan-Speak Revelator ring radiator tweeter brings out the very best in treble detail as well as extended high frequency performance. The four bass drivers now incorporate larger magnets, resulting in tighter, punchier bass. Internally, silver plated copper wiring has been used, which is teflon insulated, military specification type E wire.

Looks have also been refined, with the cabinet undergoing a complete aesthetic facelift. The trademark Neuphonix baffle scallop around the tweeter has been emphasised and streamlined with a more defined angular ridge. The cabinet is slightly smaller and the front baffle has been angled by 2.5 degrees to aim the tweeter directly towards the listener’s ear when seated at approximately 3-4m from the speakers.

Recessed into the baffle, Anniversary edition stainless steel Krix badges are always visible below the grille. The individually numbered stainless steel terminal plates feature gold plated brass binding posts and bridging bars in a tri-wire configuration.

To celebrate our rich Australian history, the Neuphonix AE40 are being offered in three Australian timber finishes: Blackwood, Redgum and Spotted Gum. The popular Black Ash finish is also available.

130mm midrange driver

130mm midrange driver

Dedicated midrange driver for pristine clarity and definition.

Quad 130mm bass drivers

Quad 130mm bass drivers

Provide speed, clarity and increased power handling.

25mm mdf baffle

25mm mdf baffle

Optimised scalloping for reduced defraction, thick front for mass and damping.

internally braced enclosure

internally braced enclosure

Reduces standing waves and cabinet resonances. Tight mid bass performance.

Frequency Range
35Hz – 40kHz in room response
Power Handling
50 – 300 Watts RMS recommended amplifier power
Sensitivity
89dB for 2.83 volts at 1 metre
Configuration
6 driver 3-way tri-wireable / tri-ampable
Bass Driver(s)
4 x nominal 130mm (5”) coated paper cones. 26mm (1”) voice coil wound on high powered aluminium former provides enhanced linearity. Over-sized magnet delivers low distortion
Mid Range Driver
1 x nominal 130mm (5”) coated paper cone. 26mm (1”) voice coil wound on high powered aluminum former, using copper shorting ring and oversized magnet for low distortion.
Tweeter
26mm (1″) dual concentric diaphragm with patented phase plug. Non-reflective, non-resonant aluminium chamber. Patented symmetrical driver neodymium motor system
Impedance
Nominally 6 Ohms (minimum 4.9 Ohms)
Enclosure Type
Dual chambers – sealed midrange chamber, with bass reflex main chamber, rear vented with internal and external flaring.
Dimensions
1045mm high x 228mm wide x 400mm deep
Weight
30kg each

Additional Information

Enquiry