Mon-Fri 9am - 5.30pm / Sat 9am - 5pm / Sun - Closed
FREE SHIPPING IN AUS(Orders Over $300)

Krix Phoenix Mk2 Floorstanding Speakers

$1,895.00 inc. GST

Description

  • more power, more clarity and more efficiency
  • tight punchy bass and revealing top-end
  • perfect for larger listening rooms

$1895 – $3415 depending on finish

Tonal depth, imaging and balanced musicality are highlights in this slim floorstanding design. Involve yourself in the experience of sound with the Phoenix Mk2. What’s different in the Phoenix Mk2? The Phoenix Mk 2 has been redesigned from the ground up, to offer marked improvements in performance and a sleeker more contemporary appearance. The woofers’ magnetic size has increased by 50% and voice coil diameter increased from 25mm to 33mm to offer higher sensitivy, greater power handling and tighter more articulate bass. The tweeter has been replaced by the same ring radiating tweeter used in Krix’s flagship model, the Neuphonix, for added vocal warmth and smooth, revealing upper treble. The cabinet has also undergone a radical overhaul departing from Krix’s traditional ‘picture-frame’ style box construction in place of a new fully mitred construction technique creating a much cleaner aesthetic free from all visible panel joints. The new construction also results in less MDF wastage, utilising waste material to create an interlocking internal ‘X’ brace system for added box rigidity and internal standing wave suppression. The speaker box plinth has also been replaced by Krix proprietary rubber feet for improved acoustic isolation on hard and soft floor surfaces.

large 26mm ring tweeter

large 26mm ring tweeter

Ring radiator with central waveguide for improved intelligibility and transparency.

dual 165mm bass drivers

dual 165mm bass drivers

Increased cone area for effortless bass delivery.

isolation feet

isolation feet

Rubber moulded feet, reduces transfer of vibrations into the floor.

x-bracing

x-bracing

Reduces standing waves and cabinet resonances. Tight mid bass performance.

Frequency Range
35Hz-40kHz in room response
Power Handling
50 – 200 Watts RMS recommended amplifier power
Sensitivity
91dB for 2.83V RMS at 1m
Configuration
Point source dual 6.5″ two-way, bi-wireable, bi-ampable
Bass Driver(s)
Dual nominal 165mm (6½”) laminated polypropylene cone. 33mm (1¼”) voice coil wound on high powered aluminium former, with ventilated spider and aluminuim flux stabilization ring for low distortion
Tweeter
26mm (1″) dual concentric diaphragm with wave-guide centre plug for controlled directivity. Non-reflective dual chambered magnet structure with copper shorting ring to lower distortion
Impedance
Nominally 6 Ohms (minimum 3.5 Ohms)
Enclosure Type
Bass reflex, rear vented (symetrix flared), with internal X bracing
Dimensions
950mm high x 195mm wide x 295mm deep (Including feet)
Input Terminals
Dual bi-wire binding post
Weight
18 kg each

Additional Information

Enquiry